Operating Procedures for Microcomputer Numerical Control Spring Testing Machine

1、 Basic structure of testing machine
The microcomputer numerical control spring testing machine mainly consists of the following parts:
1. Machine base: The supporting and fixing parts of the testing machine can be adjusted in height and level to meet different testing needs.
2. Upper crossbeam: The fixed support structure at the upper end of the testing machine, which supports the power system, sensors, and operating components of the testing machine.
3. Power system: Drive the testing machine for spring testing, including motors, servo systems, etc.
4. Sensor: By real-time monitoring and feedback of spring test data, the accuracy of the test data is ensured.
5. Operating components: including the control panel and computer of the testing machine, used to control the operation of the testing machine and display the test results.
2、 Operation steps
1. Clamp the spring to be tested onto the clamping mechanism of the testing machine and adjust the position of the clamping mechanism to ensure that the spring is in a horizontal state.
2. Turn on the power of the testing machine, connect the computer to the testing machine, and start the testing machine control software.
3. Select the testing mode and corresponding parameters of the testing machine on the computer, including the material, diameter, number of rolls, stiffness, etc. of the spring.
4. Set the operating parameters of the testing machine on the control panel, including loading rate, displacement speed, loading type, etc.
5. Start the testing machine to test the spring and monitor the test data and results in real time.
After the test is completed, turn off the power of the testing machine and remove the testing spring and the clamping mechanism of the testing machine.
3、 Precautions
Before operating the testing machine, it is necessary to first understand the basic structure and usage of the testing machine, and master the basic knowledge of safe operation.
When operating the testing machine, it is necessary to strictly follow the instructions and operating procedures of the testing machine to avoid unnecessary damage to the testing machine.
When conducting spring tests, it is necessary to pay attention to the material, diameter, number of rolls, and other parameters of the spring to ensure the accuracy of the test data.
4. During the experiment, corresponding data recording and storage are required for easy access and analysis of test results at any time.
5. After the testing machine is used, it is necessary to clean and maintain the equipment in a timely manner to ensure the long-term stability and service life of the testing machine.
Through the introduction of this article, we can understand the basic structure, operating steps, and precautions of the microcomputer numerical control spring testing machine. For personnel who need to operate a spring testing machine, this is an essential guide.